Hondata

Hi, just bought plx dm6 multigauge and lambda sensor.
I wonder how to connect it to ecu? I think that i take old lambdas off and put the car workin only with plx wideband.

Do you want to run closed loop from the aftermarket wideband or do you just need it for datalogging?

I want to run closed loop

You will have to wire the wideband signal into the analog input on the K-Pro board and then configure the analog input settings for your wideband. Then go to the closed loop settings and select the option to run on an external wideband.

Digital input works great as well, I've been running that for years now.

Does anybody have did this? Im wondering how to do wiring job correctly.

I+ and G on the kpro board connects to TX on the PLX module.

Thanks a lot. I Will test it soon

Hi, i took my old lambda out and put plx in. I selected external wideband in k-manager options. But now it gives p1166 trouble code. (Primary O2-sensor heater)
What causes this?

Try unchecking the enable sec O2, FTP, PA and ELD in the Misc section.

Digital input did not work on my hondata with plx dm6, i think i will test analog input. Can someone tell what settings i have to select In k-manager?

You just need to set the analog input to the PLX in the parameters for analog input.