Hondata

Hello everyone.

Honda civic type R ep3 eudm pra ecu 2002.

Hondata kpro v4, bolts with perfect Map on dyno. 242ch and 231nm

When i started my car i have a green light but when turn the Key for ckanking engine my Ecu light red for little moment and return green.

It's normal ? Because the car it's verry slow and loss power on the road.

It's an intermittent problèmes !!! No change parts on car and the Map it's perfect.

Are you able to datalog? Are there any errors?

My tuner doesn't explication, no cell, ,no error.

On Datalog there are not visible problems. I have a battery Odyssey PC680 and the exterior temperature around 5C°
But starting is not dificulte.

Battery it's possible cause ? two years old and complet charge with CTEK it's ok.... or Kpro card failed ?

It sounds like you may be getting a daughterboard communication error from low voltage when cranking.

When the first step "contact Key" engine off.
The light is red then green on Kpro. It's normaly ?

It's not green all Time before start engine.

You should use a multimeter at the ECU to check the voltage when cranking.

Ok.

What this Pin for read a multimeter ?

A2+ and A4-