K24 Frankenstein
Posted: Tue Oct 15, 2019 9:51 am
Hi so ive recently built a k24 frank and need bit of advice and help on what base map to run to break the engine in, the spec is as follows
2005 European civic type r (ep3)
PRA ecu with Kpro v4
K24a3 stock bottom end (european, same as usdm k24a2)
K20a2 Stock head
K20a2 stock inlet manifold
K20a2 Stock manifold with cat
2.5inch Cat back
So if anyone could guide me on which map to use or provide me with a map so i could break in my clutch and get my car MOT before i take it to dyno to get it tuned with ITBS would be much appreicated
2005 European civic type r (ep3)
PRA ecu with Kpro v4
K24a3 stock bottom end (european, same as usdm k24a2)
K20a2 Stock head
K20a2 stock inlet manifold
K20a2 Stock manifold with cat
2.5inch Cat back
So if anyone could guide me on which map to use or provide me with a map so i could break in my clutch and get my car MOT before i take it to dyno to get it tuned with ITBS would be much appreicated