Hondata

I cannot get the data logging sensors to read the 0-5v analog inputs.
I set it up correctly in the analog input tab and tested the voltage at the analog input header.
Any suggestions?

I have read multiple tech and wiring pages.
http://www.hondata.com/help/smanager/in ... meters.htm

What is the serial number that is on the s300 board inside the ECU?

Post your calibration as well as a datalog showing the issue.

Thanks for responding.

I can see values for them in the datalog. Make sure that you have a template set up that has the analog inputs setup to display and you should then see them in the graph window.

I see it now on the sensors section, I must have something setup incorrectly on the display sections.

You have selected the ECU analog inputs, and not the AN1 and AN2 analog inputs from the s300.

cseanard wrote: Tue Oct 08, 2019 9:59 am Thanks for responding.

Are you in Chattanooga? Based on the title of your log, I'm guessing so.