Hondata

Hi, trying to connect an AiM MLX2 dash to Hondata KPro 111.
have connected via AiM XEFIHKPRO as instructed.
Using KManager i cant seem to change the multiplexer to 'datalogger 9600' it only has normal or disabled options.
Firmware: 3.01
Software: 4.3.5.0
Hondata v3

Thanks in advance

You cannot use a PRA calibration. You must use a PRB based calibration for this to be available.

Thanks Spunkster, excuse my ignorance but how do i do that?

What ECU do you have?

Hi Spunkster,
do these numbers make any sense?
37820-PRC023
2070-403744
KEiHIN

When you go to the New calibration , make sure you select RSX (Type-S)-PRB based calibration and the options should be there.