Page 1 of 1
Need a diagram to wire up plx gen 4 to kpro
Posted: Thu Aug 02, 2018 6:56 pm
by Moe1786
Hi guys i need a diagram to wire up my plx device to my kpro my ecu is a pra please help
Re: Need a diagram to wire up plx gen 4 to kpro
Posted: Fri Aug 03, 2018 5:28 pm
by Spunkster
Re: Need a diagram to wire up plx gen 4 to kpro
Posted: Sat Aug 04, 2018 10:53 am
by Moe1786
So the ground wire from the plx unit must be connected to the ground on the hondata and not ground it on the body?
Re: Need a diagram to wire up plx gen 4 to kpro
Posted: Mon Aug 06, 2018 10:11 am
by Spunkster
The plx should just use a chassis ground. There is no signal ground needed.
Re: Need a diagram to wire up plx gen 4 to kpro
Posted: Mon Aug 06, 2018 2:37 pm
by Moe1786
Thank you so much
Spluttering issue
Posted: Mon Sep 28, 2020 10:42 am
by Moe1786
Hi Sir
My name is Muhammad, im from South Africa, ive got a ek civic with a k20a2 motor and kpro, im having issues with a misfire at high rpm, ive changed coil packs,plugs,injectors,fuel pump,map sensor,crank sensor added extra earths and a relay to the ecu im using ngk bkr7eix plugs my engine is almost standard i dont know what else to do to solve the problem, would it be possible for me to send a log and get some assistance?
Regards
Re: Need a diagram to wire up plx gen 4 to kpro
Posted: Mon Sep 28, 2020 1:06 pm
by Spunkster
Please start a separate thread for this and include calibration as well as datalogs showing the issue.
Re: Need a diagram to wire up plx gen 4 to kpro
Posted: Mon Sep 28, 2020 11:14 pm
by Moe1786
I don't know how to create a new post or upload a log but I can email a log and calibration