Hondata

Can anyone help me clean up this map? I set up what I could for my buddies 94 Integra, with B18c GSR motor. Below is the parts list, there is still more I recommended he do, like Oil pan baffle and misc supporting mods. I advised him to get new spark plugs and gap them or check the ones currently in as it is breaking up between 3500 - 4700 rpm, but not all the time.

Setup:
94 Integra
B18c1 GSR Motor
GSR VTEC head
Ferrea Springs, Retainers and Valves
Brian Crower Rods
Brian Crower Cams
Aries pistons - wrist pin upgrade 10.5
ARP Head Studs and bolts
Port and Polished Head
Ls Crank balanced
ACL race bearings

Edelbrock Victor X Intake Manifold
BWR RamHorn Turbo Manifold
Garrett .60 Turbo
Tial Wastegate 12 pound spring
Greddy Type S Blow off valve
Custom Intercooler & piping
OEM Oil pick up
Type r oil pump
Type r water pump
Moroso oil pan


Walbro 255 fuel pump
Injector Dynamics 1000cc Injectors

Hondata S300 ... Obviously...

Did you get this dyno or street tuned any datalogs?

No, Dyno and this is a Second-hand car that someone I know picked up, no dyno yet. Street tune, I touched it up in the 10 minutes I had to help him get the Car to his house. I have been to busy to catch up with him, the Weekend of August 3rd, I will have more time to spend with the car, and I will datalog and clean it up some more. I just want someone else eyes on it with me. There is a lot the previous owner jacked up, and he needs to clean up the wiring, connections, and hoses. I will upload a data log when I go over next weekend.

I was looking at similar maps, but is there no point in cleaning up the current map?
Or one anyone of you recommends to use, that is already on these forums?

Use mine it’s posted m. on e85

I'm still learning so my input does not need to be taken as fact but the timing looks a lil agressive once it goes into boost. What fuel are you running?