Hondata

Is there any way to change the values in this table? I'm asking because I'd like to run slightly lean at idle and cruising while using closed loop fuel control.

Thanks.

This can be changed on the closed loop advanced tab in parameters.

I thought these were controlled by going to Options > Settings > Target Lambda

The closed loop advanced parameters control what your wideband will try to actually adjust to when driving in closed loop.

Those settings will not have any effect on your closed loop operation. The settings I have mentioned are what control this.

That table in the closed loop advanced window is a bit too broad of an adjustment. I wanted to go into the tables window>"show target lambda" and adjust the idle and light throttle cruise so that it targets something a tad leaner like 15:1 but when I tried to alter the numbers it just adjusted the fuel value.