Hondata

Hi, Can you please tell me when i will be lucky enough to be able to run closed loop lambda with my AEM 30-0300 Wideband.
As far as im aware there is no Calibration set in the analog.
ATM i are running it as a custom setting to log but would really like to run CLL.
Thanks

Does this use the same calibration information as any of the existing widebands in the software?

Kinda related question...?

I wired the white wire of my 30-0300 to the ANALOG-0 on the KPRO.
I think this is how that's setup but I'm not 100% sure.

Spunkster wrote: Mon Jun 04, 2018 9:55 am Does this use the same calibration in formation as any of the existing widebands in the software?

I don't know, that's why I am asking you?
As far as I am aware there is no calibration for this wideband. In another post I read that you were working on making a calibration to suit the AEM 30-0300 in a future firmware update.
Any idea how soon this might be?

What is the calibration information required for this wideband?

Sorry I must be wording it wrong.
Under the analog table there is no conversion look up for my wideband. AEM 30-0300
Can I just use one of the ones already there so I can run in closed loop.
My map is very good already but I would like to run closed loop. From my research my wideband isn't yet able to be used to run CLL?

You are asking questions about AEM products to Hondata, normally you do your own research or ask the actual manufacturer :)
Compare the scaling table on your wideband to the ones available in kmanager http://www.aemelectronics.com/files/ins ... 0-0300.pdf
If you find one that's the same you can use that one otherwise ask Hondata nicely to ad yours.