Page 1 of 1
Log: Domain error
Posted: Sat May 12, 2018 1:29 pm
by Betzmotorsport
Hi
I can download from my ecu to kpro with 4.3.5 but when i start datalogging (F10) then pop up hundrets of error windows with the Message „log : DOMAIN error“.
What is the problem? Some months ago all was fine, but now this problem. Is it a problem with the new update?
Re: Log: Domain error
Posted: Sat May 12, 2018 4:47 pm
by Hondata
Can you post a screen shot?
Re: Log: Domain error
Posted: Sun May 13, 2018 6:58 am
by Betzmotorsport
Hope you can see it attached
Re: Log: Domain error
Posted: Sun May 13, 2018 7:00 am
by Hondata
Have you uploaded the calibration back to the KPro with the new version?
Re: Log: Domain error
Posted: Mon May 14, 2018 12:20 pm
by Betzmotorsport
Yes, but the same problem..
Re: Log: Domain error
Posted: Mon May 14, 2018 1:41 pm
by Spunkster
What is the serial number that is on the K-Pro board?
Re: Log: Domain error
Posted: Tue May 15, 2018 9:16 am
by Betzmotorsport
Serialnumber is 44525
Re: Log: Domain error
Posted: Tue May 15, 2018 9:45 am
by Spunkster
Can you please post your calibration so that we can take a look at it.
Re: Log: Domain error
Posted: Thu May 17, 2018 9:07 am
by Betzmotorsport
Which calibration do you want to see?
Re: Log: Domain error
Posted: Thu May 17, 2018 9:34 am
by Spunkster
The one you are running.
Re: Log: Domain error
Posted: Thu May 17, 2018 9:55 am
by Betzmotorsport
Sure, I hope you find something
Re: Log: Domain error
Posted: Thu May 17, 2018 10:31 am
by Spunkster
Where did you get this calibration?
Re: Log: Domain error
Posted: Thu May 17, 2018 10:35 am
by Spunkster
This is because you have negative values for the voltage offset on your analog inputs. Remove the negative value and it will not give the error.
Re: Log: Domain error
Posted: Thu May 17, 2018 12:31 pm
by Betzmotorsport
you are right!
with no negative values for the voltage it is working..
special, because I never changed it since last season and last year it worked. I think it is since I changed to update 4.3.5