Page 1 of 1
What engine "Load" is it when cranking or starting the engine?
Posted: Tue May 08, 2018 11:04 am
by G. Wiffington
This might be a dumb question but, regarding the Low, Medium, & High "Load" tables under parameters what load would it be when you are first starting/cranking the engine?
I was unsure if it would be considered High Load because the engine is just starting or would it be considered a Low Load since the car is stationary & not moving.
Re: What engine "Load" is it when cranking or starting the engine?
Posted: Tue May 08, 2018 12:19 pm
by Spunkster
It is low load as there is no load on the engine.
Re: What engine "Load" is it when cranking or starting the engine?
Posted: Tue May 08, 2018 2:35 pm
by G. Wiffington
Okay thanks.
Re: What engine "Load" is it when cranking or starting the engine?
Posted: Thu May 17, 2018 9:34 pm
by crluver123
somewhat on topic, what determines the definitive difference between low/high load, and low/medium/high load in the compensation tables? Seeking a specific measurement unit and value
Re: What engine "Load" is it when cranking or starting the engine?
Posted: Wed Oct 03, 2018 10:08 am
by G. Wiffington
The reason I was asking about this was because on my tune it was way too rich in some spots. When the temperature outside
was very hot & I shut the car off it had trouble starting because the map was so rich.
I readjusted my map accordingly & have not had a start up issue since.
Thanks
Re: What engine "Load" is it when cranking or starting the engine?
Posted: Mon Oct 22, 2018 7:23 pm
by crluver123
crluver123 wrote: Thu May 17, 2018 9:34 pm
somewhat on topic, what determines the definitive difference between low/high load, and low/medium/high load in the compensation tables? Seeking a specific measurement unit and value
I would still like to know the answer to this