Page 1 of 1
can not get kpro 4 analog to read psi???
Posted: Mon May 07, 2018 8:36 pm
by neegzoo4
Anyone here know how to get kpro 4 analog input to read PSI instead Voltage? I change the unit to PSI or bar and it still show Voltage. Oil pressure and fuel pressure is what I'm trying to do.
Re: can not get kpro 4 analog to read psi???
Posted: Tue May 08, 2018 10:30 am
by Spunkster
Can you post your calibration and datalog showing the issue?
Re: can not get kpro 4 analog to read psi???
Posted: Fri May 11, 2018 2:28 pm
by neegzoo4
Ok here is my calibrations and datalogs that I did. Let me know if I miss anything else.
Re: can not get kpro 4 analog to read psi???
Posted: Tue May 15, 2018 6:25 pm
by neegzoo4
Spunkster wrote: Tue May 08, 2018 10:30 am
Can you post your calibration and datalog showing the issue?
so Spunkster, any ideas?
Re: can not get kpro 4 analog to read psi???
Posted: Wed May 16, 2018 12:55 pm
by Spunkster
They are showing readings. The conversion table you enter must be in BAR, then you can set the unit to PSI , then in the sensor window change them units for each input to psi as well with a reasonable min and max value.
Re: can not get kpro 4 analog to read psi???
Posted: Wed May 16, 2018 2:22 pm
by neegzoo4
Spunkster wrote: Wed May 16, 2018 12:55 pm
They are showing readings. The conversion table you enter must be in BAR, then you can set the unit to PSI , then in the sensor window change them units for each input to psi as well with a reasonable min and max value.
WOW! change it to bar and it works. Thanks man.