Hondata

Seem to be having an issue with my tps in s300, or I'm being stupid... anyway, i can set the minimum and maximum reading in the tps tab, and it reads 0-100%, perfect.

The problem is the high lighted cells in the fuel and ignition tables don't match the datalog.

For example, I'm cruising at 4% tps, and the highlighted cell would be in the 6% column. Another one would be on decel, 0% tps in the log, but showing 2 or 4% in the fuel/ignition table

This is an itb set up.

Any help would be great, Thanks

In the TPS tab of parameters, what do you have the MAP value with throttle fully closed and open values set to?

Fully closed 1, and fully open 100.
On idle, my map is 44kpa, i did enter 44 in the fully closed box, but TPS and load site still didnt match

Post your calibration and a datalog showing the issue.

Attached is a short datalog, and the calibration.
The cal is work in progress, just a rough starting point to get it up and running.

You can see the issue I'm having tho