Hondata

As the title suggests. I have a PRA ecu on my ep3 and it uses a narrowband lambda sensor from the factory. Can it be made to use a wideband lambda as its primary?

Thanks

What version K-Pro do you have?

V4

Yes it can be used to input a wideband signal to run closed loop.

http://www.hondata.com/help/kmanager/an ... b=wideband

This can only be done using a V4 K-Pro.

Aa ok sweet. I already have my wideband on analogue 0 for datalogging but how do I change it over so the ecu uses this input for its lambda readings and to use closed loop?

You will see it in the closed loop tab of the parameters window.

Ok thanks 👌🏻