Page 1 of 1
Car won't start after update to 2.8.8.
Posted: Wed Jan 31, 2018 3:59 pm
by TunaCiv
I updated my R18 flashpro yesterday and since the car will not start. Is there a way to uninstall the update? Is there a fix? I NEED to start my car.
Re: Car won't start after update to 2.8.8.
Posted: Wed Jan 31, 2018 4:35 pm
by Spunkster
Are there any errors? Have you tried uploading a different calibration? Can you post the calibration and a datalog showing the issue of it not starting?
Re: Car won't start after update to 2.8.8.
Posted: Wed Jan 31, 2018 4:41 pm
by TunaCiv
I tried different calibrations, it's not giving my any codes, only DTC is a existing problem with my o2 sensor. I can get some datalogs tomorrow.
I turn the key and it keeps rying to turn over but won't ignite.
Re: Car won't start after update to 2.8.8.
Posted: Wed Jan 31, 2018 6:03 pm
by Spunkster
Did you have the O2 problem previously?
Re: Car won't start after update to 2.8.8.
Posted: Thu Feb 01, 2018 3:28 pm
by TunaCiv
I updated to 2.8.9 and problem is gone. O2 issue still there. I've replaced it twice and the code will not go away.
Re: Car won't start after update to 2.8.8.
Posted: Thu Feb 01, 2018 4:00 pm
by Spunkster
You should follow the troubleshooting steps in the factory service manual for the error code you are receiving.