Hondata

So I updated my flashpro for the active tuning now i'm getting a P0101 code and going into limp mode. It has to be the tune because a MAP based tune works fine. I've tried reading into it but can't find much info. Any help on what I might have wrong here would be greatly appreciated. :)

Oh and my car is a pretty much stock 09 FA5 if that matters?

So I updated my flashpro for the active tuning now i'm getting a P0101 code and going into limp mode. It has to be the tune because a MAP based tune works fine. I've tried reading into it but can't find much info. Any help on what I might have wrong here would be greatly appreciated. :)

Car is pretty much stock.

Looking at the top image below, your AFM flow versus voltage graph is incorrect. Somehow is is all zeros. I would open a Stock Tune and copy the values. Its just a 2 row table with mass flow values for voltages from 0-5V. I strongly suggest you turn off all active tuning until you get this corrected.

Looking at the lower image, an AFM / Speed density tune is the best IMO for near stock vehicles, but you better put a value here besides zero or the AFM will not ever be used. I would use 74 kPa so that the ECU switches from AFM to the fuel tables at higher loads only.

Great thank you! Not sure how that happened. I’ll fix that tomorrow and hopefully it’ll solve my problem! I reverted it back to stock until I was able to figure it out.

Did you ever fix your p0101 issue ?