Page 1 of 1

Newbie Question

Posted: Tue Oct 17, 2017 3:20 pm
by zerg336
Hello

Can you guys take a look at my datalog?

Short term fuel trim gets super high when idling.

Also my car sounds like a subaru. No cel.

I'm using SManager's built-in base map b16 supercharged 440cc 12ohm.

However I'm using RC 16ohm 440cc injectors.

I adjusted injector dead time accordingly (http://injector-rehab.com/shop/lag.html)



Also I downloaded b16 supercharged 440cc base map at (https://www.hondata.com/forum/viewtopic.php?f=20&t=4396)

Fuel table is different compared to built-in map.

This map have higher fuel table setting and injector size set at 550cc but file name say the map is for 440cc.



Should I use the map downloaded here or just use built-in map until I get to tuner?

My car get tuned in 2 days.

Re: Newbie Question

Posted: Tue Oct 17, 2017 3:44 pm
by Spunkster
Do you have a wideband?

Re: Newbie Question

Posted: Tue Oct 17, 2017 9:53 pm
by zerg336
I don't have it right now.

I know my tuner will provide one when tuning.

After upload base map from the link, my O2 reading has gone up.

I had it running only 5mins. It's too late and too dark outside I cant do much.

I will monitor tomorrow about O2 and how it is running.

I just want to drive safely to my tuner.

I don't like O2 reading stay close to 0.02v

I don't like to run my car lean all the time.

Re: Newbie Question

Posted: Wed Oct 18, 2017 9:21 am
by Spunkster
Without a wideband you have no accurate way of measuring air fuel ratios. You should discuss your basemap with your tuner and they should be able to help you get it to a safe point to get you to the dyno.