Hondata

Hi Hondata

How can I get my column 10 of delta fuel table activated during road tuning WOT. I am already push down to floor, you can look on tplate data.
Setup is K24A2 + 421 header.

If the air pressure is not high enough or you have intake restriction then you will not reach column 10. This is normal.

Hondata wrote: Fri Sep 01, 2017 8:35 am If the air pressure is not high enough or you have intake restriction then you will not reach column 10. This is normal.

Ok, I understand, because of my intake is still stock, do you have any experience if I change to CAI for higher flow will it obviously decrease low end torque from 1000 to 3000?

When you "open" exhaust, engine will need more air, and stock intake is restriction. CAI may help (with good velocity), but also bigger throttle plate and ported intake manifold will help. Try first with CAI, its cheeper.

on NA engine , too large throttle plate will decrease the air flow velocity and this will further decrease low end torque by geopartizing the valve overlap in that area.

If you live above about 1200 feet then you're not going to get to column 10 because of the air pressure, depending on the atmospheric conditions. It is normal.

Yes, I am living 1345 ft. So I don't need to care about column 10 then.