Hondata

I have a clutch flow controller installed that has an electronic line lock to activate it. I am going to wire it to the ecu via nit/aux 1 and use the parameters to activate it in first gear on launching via speed etc. I have a relay to wire in, is it the same wiring schematics used for the nitrous solenoid? Thanks

Without more details of this line locker it is really hard to say.

Here's the link to the actual one
http://www.biondoracing.com/product/LL.html

Since there is no info on how to wire this or any specifics given on that page, it is hard to say how it should be wired exactly. You can try using the same instructions s the nitrous control and see if that works.

Here's the instructions that came with the solenoid

Is this correct?

It should be wired exactly like the nitrous solenoid in the help file: http://www.hondata.com/help/smanager/ni ... ub=nitrous

Excellent thanks, so 30 and 86 go to the same 12v switched source

yes

Thanks again Spunkster!!! Always great service!!

Is this the same as in KPRO?

I'm trying to do the exact same thing.

Please see: http://www.hondata.com/help/kmanager/ni ... ub=nitrous