Hondata

Hello, i have a JDM GSR B18c with Type R cams. I started the car with my new s300 with a GSR Tune i found here and it ran for a bit then the timing went off. Does anyone know how to figure out what TDC Degree i have to set it as ? i know i have to advance it because i have to run 93 cause of the cams. Thanks

GSR requires 91 or higher no matter what

what do you mean the timing went off?

At one point after a start up, the car kept cranking but no startup. I was getting spark and Fuel. My buddy and i concluded that the timing was off again. now im trying to figure out which BTC to set it up to

JdmGsr17 wrote: Thu Jul 20, 2017 3:50 pm At one point after a start up, the car kept cranking but no startup. I was getting spark and Fuel. My buddy and i concluded that the timing was off again. now im trying to figure out which BTC to set it up to

you set it to 0 when the engine is off with the cams at TDC with no cam degree adjustment

when the engine is on - fully warmed up at normal idle speed. check it with the timing gun and set it to 16BTC

what calibration did you use? I don't think i saw any GSR with ITR cams map.

Put a stock GSR map on it and see if it starts up but don't drive on it

i used this tune - https://www.hondata.com/forum/viewtopic ... 293#p93293

and will do. going buy a timing light gun tomorrow