Page 1 of 1
Closed Loop Target Lambda only works for v4?
Posted: Sun Jul 09, 2017 5:06 pm
by akep
I can't seem to get this v3 to change AFCMD from 14.7 to following Target Lambda tables, I just did it on 3 v4 ecus with success. Help file doesn't mention which version supports it, if different. Am I missing something or is it only a v4 thing?
Re: Closed Loop Target Lambda only works for v4?
Posted: Mon Jul 10, 2017 7:55 am
by Hondata
Which target lambda tables - the ones in the calibration window or in the tables window?
Re: Closed Loop Target Lambda only works for v4?
Posted: Thu Jul 13, 2017 4:51 pm
by akep
the one from parameters > adv closed loop > target lambda low/high button - which brings up the table window for such
Re: Closed Loop Target Lambda only works for v4?
Posted: Fri Jul 14, 2017 10:19 am
by Spunkster
What wideband are you using?
Re: Closed Loop Target Lambda only works for v4?
Posted: Fri Jul 14, 2017 11:51 pm
by akep
PRB. if i turn it on, it will just correct to 14.7, if i turn it off it follows fuel map. AFCMD stays 14.7 no matter what i change it to.
Re: Closed Loop Target Lambda only works for v4?
Posted: Mon Jul 17, 2017 11:02 am
by Spunkster
Yes this is for the v4 only. It clearly states this in the parameters window.