Hondata

A few days ago I did a tuning of a FA5 2009 k20z3 car with a very old map. When installing my map the launch control stopped working.
With the previous map it was not necessary to have the foot in the clutch

The car has no mechanical problems .. the cruise control works perfectly. Any idea of this problem?..

If I accelerate instead (1) with the foot in the clutch the rpm goes to court

Hello Hondata support
Can you help me with this

A few days ago I did a tuning of a FA5 2009 k20z3 car with a very old map. When installing my map the launch control stopped working.
With the previous map it was not necessary to have the foot in the clutch

The car has no mechanical problems .. the cruise control works perfectly. Any idea of this problem?..
If I accelerate With clutch pressed the rpm goes to court 8,600 rpm

If I upload the old map the problem is solved .. the old map does not show progress bar or gas mix in rpm gauge

Post the calibration. Is it a Race calibration?

Is a car of daily use. With header, intake, etc.
Attached map

This map I am using it in other cars and do not have the problem with the launch

From Help, About, what is the version of software that you are using?

FP 32 bit
ver 2.7.3.0

Please download the newest version of software form the website and see if that resolves the issue you are having.

Install the latest version and update the map and the FP. The fault persists.
I attached a log

Launch control will only work when the vehicle is stationary and the clutch is depressed.

I know but it is not working