Page 1 of 1
Lambda Overlay and Fuel Adjustment Tables Always Blank
Posted: Sun Jun 04, 2017 11:03 pm
by bdtan
HI,
My KPro v4.3.3.0 has always shown blank tables when I view the Lambda, Lambda Overlay and Fuel Adjustment tables.
How can I get these to display?
KPro Wideband Input Settings 20170605.jpg
KPro Lambda Overlay Settings 20170605.jpg
Thanks,
Ben
Re: Lambda Overlay and Fuel Adjustment Tables Always Blank
Posted: Mon Jun 05, 2017 10:12 am
by Spunkster
What is the serial number that is on the K-Pro board inside the ECU?
They will only work when you use an external wideband input into the ELD input.
Re: Lambda Overlay and Fuel Adjustment Tables Always Blank
Posted: Tue Jun 06, 2017 9:57 pm
by bdtan
hondata_KPro_v4_board_2017.jpg
I have my wideband connected via analog input #1. Will that not work? My ELD is taking the input from my Hondata Traction Control. Is there no way to run both the wideband input and the Traction Control simultaneously?
Re: Lambda Overlay and Fuel Adjustment Tables Always Blank
Posted: Wed Jun 07, 2017 9:30 am
by Spunkster
Do not use the settings under options settings for this. If you are using an aftermarket wideband input into the K-Pro analog input then you must make that selection in the closed loop settings tab of parameters. This is the only way it can use an aftermarket wideband as it would an OEM wideband.
Re: Lambda Overlay and Fuel Adjustment Tables Always Blank
Posted: Tue Jun 20, 2017 4:35 pm
by hsitko
Did you ever figure this out? i'm having the same problem. My cells are all blank...
Re: Lambda Overlay and Fuel Adjustment Tables Always Blank
Posted: Tue Jun 20, 2017 4:53 pm
by Spunkster
without the calibration and datalogs showing the issue it is hard to speculate what it might be.
Re: Lambda Overlay and Fuel Adjustment Tables Always Blank
Posted: Tue Jun 20, 2017 6:13 pm
by hsitko