Page 1 of 1

i dont know how to read datalogs

Posted: Mon May 22, 2017 8:18 pm
by firelu21
i did a few quick burst runs on 9psi, could anyone tell me if they see anything wrong? i do not know how to read datalogs

Re: i dont know how to read datalogs

Posted: Tue May 23, 2017 6:35 am
by R-12914
Do you have a boosted engine without a intercooler?
What Map-Sensor do you have build-in?
FPM shows me a maximum boost of 1,52 bar / 22 PSI!

In part throttle, you must do a little bit fine tuning, to reach a s.trim vs. afm.c +/-5 (optimal).
In WOT your Engine runs a little bit too rich.

But it is always more useful to post your calibration, too!

Re: i dont know how to read datalogs

Posted: Tue May 23, 2017 2:06 pm
by firelu21
yea its a 2017 honda civic hatch 1.5 turbo cvt.i have and aftermarket intercooler and 2.5 pipe,and intake.stock map
i attached the map i ran for a day