Page 1 of 1
Replicated MT. 9psi map for Cvt. But...
Posted: Sat May 20, 2017 2:24 pm
by firelu21
Anyone know if this is a good ideal? I took all the numbers from the mt 1.5t +9psi map. And put all the same numbers in calibration and saved . But I'm not sure if it's something that can just be done, or if there's more to it.
Re: Replicated MT. 9psi map for Cvt. But...
Posted: Mon May 22, 2017 9:21 am
by Spunkster
No, it cannot be this way, there is more to it. Even if this were possible, it is not recommended, as it would damage the CVT.
Re: Replicated MT. 9psi map for Cvt. But...
Posted: Mon May 22, 2017 8:07 pm
by firelu21
here is a few short burst runs and some driving, i wish i could learn how to read these logs. i don't know whats bad or not