Fault with Flashpro hardware after update to 2.6.8
Posted: Wed May 17, 2017 7:36 am
As of yesterday I am experiencing problem and error message after I updated FP manager software. I cannot load a cal to FP unit but it will datalog. Message is same each time...
The last Flashpro update failed.
Failure information : Code 0 Step 0 Address 0x000000
Explanation: There is a fault with the Flashpro hardware.
Serial number is FP-2012Si-113381
Have tried uninstalling and re installing FP manager. Continue to get the same message.
Please advise
The last Flashpro update failed.
Failure information : Code 0 Step 0 Address 0x000000
Explanation: There is a fault with the Flashpro hardware.
Serial number is FP-2012Si-113381
Have tried uninstalling and re installing FP manager. Continue to get the same message.
Please advise