Page 1 of 1
Convert tables Fuel MAP a AFM
Posted: Sat Apr 01, 2017 4:35 am
by tiozes
Hi,
I have an FN2 with turbo with cal RACE and I want to put AFM calibration using IAT sensor and to deactivate AFM, how do I convert the fuel tables for a correct operation?
regards
Re: Convert tables Fuel MAP a AFM
Posted: Sun Apr 02, 2017 4:11 am
by R-12914
You must make a fully retune!
Re: Convert tables Fuel MAP a AFM
Posted: Mon Apr 03, 2017 10:14 am
by mladjan
Ok, it should be retuned, but can someone post some guidance which settings in the map itself are different? What we should be aware when doing this conversion?
I also have rotrex supercharged fn2 with race calibration, and would like to create one more map which is Hybrid.
If I copy/paste tables, will car be drivable for tuning, or safe at least?
Re: Convert tables Fuel MAP a AFM
Posted: Tue Apr 04, 2017 1:36 pm
by typer86
Yes and yes. But use the vtc profile and ignition what I sent to you ;)
Lock cams 50 and Rev it at first to 5000 or 6000 RPM and watch the lambda is 0.80...
Adjust the fuel and repeat this for all other cam angles
Re: Convert tables Fuel MAP a AFM
Posted: Thu Aug 17, 2017 6:00 pm
by tiozes
To work the AFM sensor has to be installed? Or can I remove it and have only the MAP sensor?
Re: Convert tables Fuel MAP a AFM
Posted: Fri Aug 18, 2017 9:29 am
by Spunkster
You can disable it, there really is no need to completely remove it. IT contains the IAT sensor so if you do remove it, you must wire in a proper IAT sensor as well.
Re: Convert tables Fuel MAP a AFM
Posted: Wed Aug 23, 2017 3:14 am
by typer86
Spunkster wrote: Fri Aug 18, 2017 9:29 am
You can disable it, there really is no need to completely remove it. IT contains the AIT sensor so if you do remove it, you must wire in a proper IAT sensor as well.
Yes IAT relocation is recommended...