Page 1 of 1
smooth 2D lines or constant AFR
Posted: Thu Jan 12, 2017 3:41 am
by janiscrulzz
i tune fuel in kpro. 2D lines looks bumpy but afr is 14,7 in part throttle and 12.8-13;1 wot. do i need to make 2D lines smooth or most important is AFR?
Re: smooth 2D lines or constant AFR
Posted: Thu Jan 12, 2017 10:19 am
by Spunkster
They should not be jagged. You can go through and artistically smooth them out.
Re: smooth 2D lines or constant AFR
Posted: Thu Jan 12, 2017 11:32 am
by janiscrulzz
When I smoot them out I take a look at datalog the AFR line is jagged. Whats better smooth 2d fuel lines or smooth AFR line?
In 2D map lines did not cross each other.
Re: smooth 2D lines or constant AFR
Posted: Thu Jan 12, 2017 2:02 pm
by Spunkster
When done properly you should have both smooth lines and smooth AF ratio. Post your calibration.
Re: smooth 2D lines or constant AFR
Posted: Sat Jan 14, 2017 12:56 am
by janiscrulzz
Please take a look at low cam 2D fuel lines.
Re: smooth 2D lines or constant AFR
Posted: Mon Jan 16, 2017 10:19 am
by Spunkster
That looks ok