Page 1 of 2
Aem wideband
Posted: Sun Nov 06, 2016 9:39 am
by pipodeluna
I'm using the aem analog wideband connected my flashpro for 2 months and suddenly stopped working on FP sensor display :( all wire connections is good. Anyone experiencing this problem? TIA
Re: Aem wideband
Posted: Thu Nov 10, 2016 12:10 pm
by pipodeluna
anyone how to resolve the problem?
Re: Aem wideband
Posted: Thu Nov 10, 2016 3:42 pm
by Spunkster
What vehicle, what version of software?
Re: Aem wideband
Posted: Fri Nov 11, 2016 12:17 am
by pipodeluna
Civic si 2008
Flashpro manager 2.4.9.0
Re: Aem wideband
Posted: Fri Nov 11, 2016 10:48 am
by Spunkster
Post your calibration and a datalog showing the issue.
Re: Aem wideband
Posted: Fri Nov 11, 2016 11:28 am
by Pipo
here's my calibration and datalogs
Re: Aem wideband
Posted: Fri Nov 11, 2016 1:48 pm
by Spunkster
according to the datalog there is no voltage being input. Have you used a multimeter to check the voltage from the wideband?
Re: Aem wideband
Posted: Fri Nov 11, 2016 2:19 pm
by pipodeluna
you mean the white wire (0-5 voltage input) ?
Re: Aem wideband
Posted: Fri Nov 11, 2016 3:34 pm
by Spunkster
Whichever is the signal wire from the wideband.
Re: Aem wideband
Posted: Fri Nov 11, 2016 5:12 pm
by pipodeluna
Here's what I've got on the analog output wire (white wire)
Re: Aem wideband
Posted: Fri Nov 11, 2016 5:13 pm
by Spunkster
Is it a constant 2.27 volts at all times?
Re: Aem wideband
Posted: Fri Nov 11, 2016 5:28 pm
by pipodeluna
Yes
Re: Aem wideband
Posted: Fri Nov 11, 2016 5:37 pm
by Spunkster
If it is a constant voltage you either have a bad sensor, or the wideband controller is damaged.
Re: Aem wideband
Posted: Fri Nov 11, 2016 5:50 pm
by pipodeluna
I've tested it in a new wideband & sensor still not working :(
Re: Aem wideband
Posted: Mon Nov 14, 2016 10:20 am
by Spunkster
I would recommend that you contact AEM for assistance with why the output voltage is not changing.