Page 1 of 2
S300 v2 solid cel car won't start
Posted: Fri Nov 04, 2016 8:19 am
by TeGgYBwOi
Car was tuned back in September everything worked fine til last weekend went to the track unloaded off the trailer drove to staging lanes and bang car won't start anymore 2 green lights come on initially then the USB flashes red once other light stays green... I pulled the s300 and put it in my bone stock eg and it starts but cel stays solid anyone else have this problem? Could it be possible that it reset itself? Cause I'm almost a thousand percent sure that car tuned for id 1000's isn't starting a bone stock car... please some input shit driving me nuts
Re: S300 v2 solid cel car won't start
Posted: Mon Nov 07, 2016 10:40 am
by Spunkster
Can you datalog? Have you tried re-uploading your calibration to the ECU?
Re: S300 v2 solid cel car won't start
Posted: Wed Nov 09, 2016 9:45 am
by TeGgYBwOi
Spunkster wrote:Can you datalog? Have you tried re-uploading your calibration to the ECU?
Yes I have to disconnect/connect the battery reupload the tune car starts and idles as it should but if I turn the car off and then go to start it again same problem
Re: S300 v2 solid cel car won't start
Posted: Wed Nov 09, 2016 10:25 am
by Spunkster
What is the serial number that is on the s300 board inside the ECU?
Re: S300 v2 solid cel car won't start
Posted: Wed Nov 09, 2016 10:38 am
by TeGgYBwOi
Spunkster wrote:What is the serial number that is on the s300 board inside the ECU?
At work right now is there any other way to get that info? It is registered
Re: S300 v2 solid cel car won't start
Posted: Wed Nov 09, 2016 10:56 am
by Spunkster
No, you will need to look on the board inside the ECU.
Re: S300 v2 solid cel car won't start
Posted: Wed Nov 09, 2016 11:12 am
by TeGgYBwOi
Spunkster wrote:No, you will need to look on the board inside the ECU.
Ok I'll post it up later
Re: S300 v2 solid cel car won't start
Posted: Thu Nov 10, 2016 8:26 am
by TeGgYBwOi
Spunkster wrote:No, you will need to look on the board inside the ECU.
23063
Re: S300 v2 solid cel car won't start
Posted: Thu Nov 10, 2016 10:29 am
by Spunkster
So is it having the problem with having to upload in the race car and the stock car?
Re: S300 v2 solid cel car won't start
Posted: Thu Nov 10, 2016 3:12 pm
by TeGgYBwOi
Spunkster wrote:So is it having the problem with having to upload in the race car and the stock car?
I mean I have to pull the battery n load map every time I wanna start the car
Re: S300 v2 solid cel car won't start
Posted: Thu Nov 10, 2016 3:43 pm
by Spunkster
but is it doing the same thing on both vehicles?
Re: S300 v2 solid cel car won't start
Posted: Thu Nov 10, 2016 7:57 pm
by TeGgYBwOi
Spunkster wrote:but is it doing the same thing on both vehicles?
Yea solid cel in both only difference is it'll start the stock car with the solid cel but won't start the race car without the extra stuff
Re: S300 v2 solid cel car won't start
Posted: Fri Nov 11, 2016 10:46 am
by Spunkster
From Help, About, what is the version of software you are using?
Re: S300 v2 solid cel car won't start
Posted: Fri Nov 11, 2016 1:47 pm
by TeGgYBwOi
Spunkster wrote:From Help, About, what is the version of software you are using?
The newest version
Re: S300 v2 solid cel car won't start
Posted: Fri Nov 11, 2016 3:33 pm
by Spunkster
what is the actual version number?