Hondata

Hello I was wondering if anyone knew what wire to use to data log
On the
0-100 PSI Sensor - #RTD-WB-762 from
Innovative Motorsport
Link is on the bottom
I know the red wire is switch 12
Black is to ground, but they ask you to use a control module for it.
I was wondering if anyone on here have use this fuel pressure sensor just by it self.
And how did you wire it up for the datalog input signal?


http://www.innovatemotorsports.com/xcar ... 265&page=1

If they say you need a control module for it, then you probably need that. You should contact Innovative about this as they should be able to give you the correct info.

Spunkster wrote:If they say you need a control module for it, then you probably need that. You should contact Innovative about this as they should be able to give you the correct info.

I will thank you for your feed back!
What fuel sensor do you recommend.
The AutoMeter?..
Any other brands

They all seem the same part underneath. I'd use the Autometer.

I was wanting to put a fuel pressure sensor in my car. Can the s300 v3 do this?

Nevermind. I answered my own question.