Hondata

Hello!

I just purchased a socketed ECU online and I just purchased a used S300 V1. When I turn on the vehicle the s300 had a solid red light. I can open SManager and I can see information under the information tab, download from ECU and datalog; But I just can't upload anything. I would open a new calibration file change injector params and upload it but I would get the upload failed message.

I've erased the ECU successfully as well. I can do just about anything except for uploading.

Do you guys have any ideas?

Serial: 8706

For the sake of information; I was able to find a solution. The instructions from this thread fixed it for me:

http://www.hondata.com/forum/viewtopic.php?t=15618

Essentially I switched the ignition to ON (S300 is RED)
Went to Online then download
I then reuploaded the calibration I just downloaded from the ECU
And bam! No more RED light and I can upload maps now.