Hello!
I just purchased a socketed ECU online and I just purchased a used S300 V1. When I turn on the vehicle the s300 had a solid red light. I can open SManager and I can see information under the information tab, download from ECU and datalog; But I just can't upload anything. I would open a new calibration file change injector params and upload it but I would get the upload failed message.
I've erased the ECU successfully as well. I can do just about anything except for uploading.
Do you guys have any ideas?
Serial: 8706
S300 V1 - P75 US - 1994 Honda Accord F22B1
-
teknicalissue
- Posts: 2
- Joined: Sat Sep 03, 2016 1:08 pm
-
teknicalissue
- Posts: 2
- Joined: Sat Sep 03, 2016 1:08 pm
Re: S300 V1 - P75 US - 1994 Honda Accord F22B1
For the sake of information; I was able to find a solution. The instructions from this thread fixed it for me:
http://www.hondata.com/forum/viewtopic.php?t=15618
Essentially I switched the ignition to ON (S300 is RED)
Went to Online then download
I then reuploaded the calibration I just downloaded from the ECU
And bam! No more RED light and I can upload maps now.
http://www.hondata.com/forum/viewtopic.php?t=15618
Essentially I switched the ignition to ON (S300 is RED)
Went to Online then download
I then reuploaded the calibration I just downloaded from the ECU
And bam! No more RED light and I can upload maps now.