Hondata

Is there a difference in which method i wire my mtlx to the ecu, i have it on analog 0 but was just wondering if there was a benefit in going digital.Kpro 4 99 ek k20a3

It is your own personal preference. They do the same thing.

Spunkster wrote:It is your own personal preference. They do the same thing.

Ah I see

1 more question, I'm using analog 0 for my mtx-l do I need to input any values in kmanager for the sensor. I just programmed the sensor and wired it in but didn't make any changes in kmanager in terms of values now my Guage and kpro read8ng is off by about 10 points, I know I'm missing something here

YOu need to enter the correct values for the wideband you are using, or the software has no idea what to do with the input data.

Spunkster wrote:YOu need to enter the correct values for the wideband you are using, or the software has no idea what to do with the input data.

OK I guess this is my issue. Gonna go outside and mess with it, will post results

So I tried the custom input but now kpro only reads 14.70 and doesn't change lol

Ok I selected innovate lc2 now she reads pretty dam close I'm happy with that not for some logging g