Hondata

Hello I have flashpro Accord 2008-2010 Outside Americas SN FP-ACRD-INT-150017 and ecu that has ecu cal number 37820-rl6-e55, that does much Flashpro controller. But when i try to lock to vin the error occures. The curent vehicle is Unknown. But in the in ecu data I have e vin JHMCU2650DC2000xx(x=numbrers), and calibration id 37805-rl6-e55. On the ecu Ticket we have a number 37820-rl6-e55. Please help , or take an adviece how to solve that problem.

From Help, About, what is the version of software you are using?

The latest one from hondata website.
I think the problem is that there is no such a number of calibration id in flash pro. My ecu sticker has a number that much to my flashpro, but the car is 2012 my restyle version and it has another version of cal id inside the ecu as i described earlier. May be there is the way how to update calibration for example through the HDS system? Or you can fix it in next build of your software .

I'm sorry, but the 2012 is not supported. This is why it specifically says it is for a 2008-2010 International Accord. There will be no updates to allow it to work.

May be it can help , if download the dump from the ecu and send it to you for further hondata support ?

Spunkster wrote:I'm sorry, but the 2012 is not supported. This is why it specifically says it is for a 2008-2010 International Accord. There will be no updates to allow it to work.

so that is what i have on the screen.

I can download fulldump with piasini..

So that is the dump. Pls do something ,this can help. I hope you will help . thanks

What you are asking is for us to support a new vehicle. We'll look and so how much work this would be.

I wonder that software model is the same, and it is not new vehicle support. Software have the same algorithms, tables, and bit mask, but their addresses is differet. My ecu have ecu number that suppurted by hondata flashpro interface. I dowlnoaded full dump from my ecu and send it to this official support forum. And it would be great if hondata take care of their customers and support for this firmware id. Hope you will do that. Thank you .

Hi... So any news? How much time could it take? Thanks.

Please give us a chance to look at this first.

So send tou you piasini full dump..

Please don't post ECU dumps on this forum. We already have the E56 binary.

It is not similar to the 08-10 binaries nor the US TSX 20120 binary, so sorry, we can't do anything for you.

So i waste my money for piece of junk.. Thank you guys.. Will try to sell this garbage.. By the way the ecu have identically same hardware as 2010 car.