Page 1 of 1
Calibration D17a
Posted: Tue Aug 02, 2016 9:13 am
by sajnor
Hello! Install version 4.2.6 stopped working table Fuel Adjustment (shows the estimated adjustment to the fuel table necessary to alter the measured lambda to meet the target lambda). What could be the problem ?
Re: Calibration D17a
Posted: Tue Aug 02, 2016 9:54 am
by Spunkster
They are showing here, have you tried restarting the laptop?
Re: Calibration D17a
Posted: Tue Aug 02, 2016 9:35 pm
by sajnor
four computers tried! White table no indications (
Re: Calibration D17a
Posted: Tue Aug 02, 2016 9:47 pm
by sajnor
Re: Calibration D17a
Posted: Wed Aug 03, 2016 9:39 am
by Spunkster
Post the settings you have under Options, Settings, Lambda overlay.
Re: Calibration D17a
Posted: Fri Aug 05, 2016 9:06 am
by sajnor
I ustanovlina one lambda aem uego, podklyuchina on foot E15, I set it up in the Wideband Input Settings
k
Re: Calibration D17a
Posted: Fri Aug 05, 2016 9:10 am
by sajnor
kmanager 3.2 rabotalya all good!
Re: Calibration D17a
Posted: Fri Aug 05, 2016 9:13 am
by sajnor
Settings, Lambda overlay, I did not set up, do not know how
Re: Calibration D17a
Posted: Fri Aug 05, 2016 9:35 am
by Spunkster
You cannot use an external wideband with the lambda overlay tables unless you have a V4 K-Pro and input it into one of the K-Pro board inputs.
Re: Calibration D17a
Posted: Fri Aug 05, 2016 7:09 pm
by sajnor
advise what I should do
installed kpro v3
Re: Calibration D17a
Posted: Mon Aug 08, 2016 6:11 am
by sajnor