Hondata

Hey guys, I'm working with an '08 S2000 CR. I've been uploading calibrations from my e-tuner and datalogging the pulls to the FlashPro module. Last week was the first round of testing and everything went smoothly. I was re-sent calibrations this week and ran those as well, but unfortunately I'm having a helluva time getting the data logs off my FlashPro unit.

I'll try to download or save (I'm not sure what the difference is) these to my desktop (I tried other directories too), but nothing will show after the progress bar has hit 100%. An error(?) at the bottom left of the FlashPro Manager appears after it's complete. "FlashPro in boot loader." No clue what that means, and nothing in the help section that I could find.

- I've tried three computers now and they've all had the same issue
- I'm using the latest version of FlashPro Manager 2.4.2.0

It's strange because I've had no issue uploading calibrations to the car, and I was able to save these datalogs after last week's first round of testing without problem.

Any ideas to get these datalogs off the FlashPro? I attached an image showing the boot loader message.

Thanks for your help!

If you unplug the FlashPro completely and then plug it in only to the USB, does this go away?

Yes sir, it does. I'm baffled. But I noticed another thread on this board with a similar problem:

https://www.hondata.com/forum/viewtopic ... 29&t=19551

Hopefully I don't have to redo all that testing..

I would recommend that you delete the datalogs and try again.