Hondata

I'm doing a tune for ITB's in an S2000 with KPro with Alpha-N, and can't figure out how to get KManager to display suggested fuel changes on the fuel tables. I'm not able to view the sensor overlay either. Any suggestions?

What wideband do you have and how is it being input into the ECU?

It is an AEM UEGO wideband connected to Analog 0 (KPro 4). The KPro reads the value fine, and is using it for closed loop operation without any issues.

Here is a datalog...

You need to post the calibration as well.

Here is the calibration.

Seems to work fine here when both the calibration and datalog are loaded.

Could it be my settings in KManager? Here is my ini file.

Are you able to view the suggested fuel adjustments?

I was able to view some data using the sensor overlay, but not the A/F value. I have tried various settings for the Wideband input, but haven't found one that works.

I just now got the sensor overlay to work, but still not the "Display fuel adjustment values" view.

Make sure you have the calibration as well as the datalog opened together or it will not work.

They are both open. I am able to live tune while datalogging, but I just can't see the suggested fuel changes.

What settings do you have under Lambda overlay?

I think all those settings are in the INI file I exported, and attached to a post above. However, here are some screen shots.

Oh snap! I just noticed that the datalog has -20 degrees for cam angle, so it's being filtered out! After changing my cam angle filter to include -50 to 50, all the fuel adjustments showed up!