Hondata

Hello all,

I just received my kpro v4 from Hondata and I have an HP Notebook for a laptop. I see where it says Install USB drivers with either XP or Vista, but I am really unsure of what to do. When I plug the ecu into my computer nothing comes up automatically for the drivers and the directions I was sent to install the drivers manually were very unclear and vague. Is it possible to get some directions/ help as to what to do please or perhaps a point in the right direction? I am simply trying to load a stock base map for my k20z1 to drive it until I am able to get it fully tuned.

Thanks and looking forward to the help guys

From Help, About, what version of software are you using?

What operating system are you using?

Hi Spunkster,

Under Help and about it says I am using version 4.2.6.0 . This I believe is the latest version correct?

And the operating system is windows 10. I just tried again by plugging it in and I checked the bottom left again and it said drivers installed although I didnt get any notifications. Checked device manager and it showed up there as well. Would this mean I can now plug it in to the car and upload the calibration and it should be fine?

Thanks

It sounds like it is working as it should.

Okay I'll try it in the vehicle tomorrow an let you know. Thanks for the help.