Hondata

I just sent my ecu for upgrade at Hondata but now when I've got it back the car won't start it's acting weird no sensors are being read by the ecu nothing.
I also had the boost by gear components installed.
My question is:

Is it possible to have the boost by gears components installed but not be running boost by gear set up?
Could u still use it for waste gate pressure set up? I did that for future upgrades. I was planing to run boost by gear in the future so I decided to have it done. But like I said the car doesn't want to start or anything.

You should still be able to use it without boost by gear. Did you upload your calibration to the ECU?

yes i did. i put back the copy of the same calibration that was taken from the ecu before it was sent for upgrade

That calibration may be corrupt. Have you tried uploading a new calibration from the New calibration button?

yes and i have different calibration that i have had from the past. nothing works the check engine light is on. No sensors or anything read on the laptop no error codes nothing

What is the serial number that is on the s300 board inside the ECU?

From Help, About, what is he version of software you are using?

2530 is the firmware version and the serial ill have to check it out when i get home from work