Hondata

Are there any changes that need to be made in sManager when switching from a P72 with S300 v3 to a P28 S300 v3?

I have disabled the knock sensor via sManager and uploaded the same map present on the P72. The car will start and idle on the P28, but when I attempt to drive it the AFR immediately leans out and the car starts lurching.

Any assistance is greatly appreciated.

Without more specific details of the setup, the calibration and a datalog showing the problem, it is really impossible say what it could be.

Gotcha. Wasn't sure if there was a setting I needed to turn off or anything. I'll gather the suggested info and see if I can get a datalog and come back.

Thanks for your time.