Page 1 of 1
CAN output v4
Posted: Thu May 26, 2016 7:20 pm
by Korn4900
Is it possible to use the CAN outputs on the digital input for a factory honda CAN bus?
Re: CAN output v4
Posted: Fri May 27, 2016 9:24 am
by Hondata
What are you trying to do?
Re: CAN output v4
Posted: Fri May 27, 2016 9:27 am
by Korn4900
The RDX rear diff usses the can bus to communicate with 4 other sensors and the PCM and abs unit
Re: CAN output v4
Posted: Fri May 27, 2016 10:03 am
by Hondata
The KPro CAN output is for datalogging and has a couple of different formats. I'f you're trying to control the RDX differential, then this is outside the scope of what the KPro output can do.
Re: CAN output v4
Posted: Fri May 27, 2016 10:07 am
by Korn4900
Would it be able to output the correct format to use let's say a TSX cluster?
Re: CAN output v4
Posted: Fri May 27, 2016 10:23 am
by Spunkster
No, it is not designed for this.
Re: CAN output v4
Posted: Tue Dec 06, 2016 12:19 pm
by SilverRD1
why not? there is a demand for it now. make it happen please.