Hondata

I have been successfully datalogging EGT and digital AFR from my PLX serial stream on the digital inputs but recently they stopped working on their own. Inside the sensor setup they both show as type "voltage" instead of degrees F and AF ratio, and I can't change the type. How can I change these back to the correct units, or reset the digital sensors so I can manually add them in the digital input parameters again?

The sensor units are set from the datalog, not the calibration, so if you set the parameters correctly and upload, then a datalog made with those settings should use the correct units. Sorry it is a little unclear but this way a datalog will display correctly without needing to set the sensor units for each different datalog.