Page 1 of 1
What is "VTC Closed Loop Control" -> "VTC P-I-D"
Posted: Thu Apr 07, 2016 11:52 pm
by R-12914
Hi Hondata,
what is the new option under "VTC" -> "VTC Closed Loop Control" -> "VTC P-I-D" like this:
7b7f475a-f7bc-42fd-ae89-d3bccd746138.jpg
In the help-file is not, once again, what does this changes are mean!
Again:
Hondata, if you make updates/modifies, please also updates the help-file, so the tuner / user to know what is meant by the changes!
We are all no clairvoyant, even if it was sometimes beautiful! ;)
Please make it so in the future, then it saves us/you a many work and we do not always have to ask!
Thanks!
Re: What is "VTC Closed Loop Control" -> "VTC P-I-D"
Posted: Fri Apr 08, 2016 9:03 am
by pepperdanky
Correct for error between cam commanded and actual?
https://en.wikipedia.org/wiki/PID_controller
Re: What is "VTC Closed Loop Control" -> "VTC P-I-D"
Posted: Mon Apr 11, 2016 7:51 am
by Hondata
It is in there for testing. It will be fully documented at a future date, but in short it is the PID parameters for VTC control.
Re: What is "VTC Closed Loop Control" -> "VTC P-I-D"
Posted: Tue Apr 19, 2016 9:59 am
by spunleta
Hey guys just to let you know, i'm having some inconsistences in vtc angle, using hybrid map. I think this is causing by this VTC P-I-D, causa in MAP cal. i don't have it. In attachments both logs. Hope instructions soon.
Re: What is "VTC Closed Loop Control" -> "VTC P-I-D"
Posted: Tue Apr 19, 2016 11:48 am
by Hondata
Have you changed the PID values? If not, we have not - the table was always there.
Re: What is "VTC Closed Loop Control" -> "VTC P-I-D"
Posted: Tue Apr 19, 2016 2:36 pm
by spunleta
Hondata wrote:Have you changed the PID values? If not, we have not - the table was always there.
No i didn't change P I D values.
Re: What is "VTC Closed Loop Control" -> "VTC P-I-D"
Posted: Tue Apr 19, 2016 3:16 pm
by pepperdanky
I had the same problem after updating to 2.3.6.0. After reflashing the calibration again it went back to normal. Cal and logs attached.
Re: What is "VTC Closed Loop Control" -> "VTC P-I-D"
Posted: Fri Apr 22, 2016 9:12 am
by spunleta
Thanks guys! After the software upgrade, and the new input in VTC I, it's correct.