Page 1 of 1
Reverse Lockout
Posted: Tue Jan 12, 2016 6:09 pm
by bian.yy
Hello Hondata
I've purchased a 07 AT TSX ECU for power my car by flashpro, If I'm going to buy a flashpro and adaptor cable will I have capability to enable Reverse Lockout? If yes, how can I do that?
Cheers!
Bian.YY
Re: Reverse Lockout
Posted: Wed Jan 13, 2016 10:50 am
by Spunkster
What vehicle is this being used with?
Re: Reverse Lockout
Posted: Thu Jan 14, 2016 8:21 pm
by bian.yy
Spunkster wrote:What vehicle is this being used with?
My car is hybrid by a accord CM chassis, TSX K24A2 engine, 07-08 tsx 37820-rbb-a71 ecu, accord euro R CL7 6-speed manual transimission.
Re: Reverse Lockout
Posted: Fri Jan 15, 2016 10:45 am
by Spunkster
I'm sorry, but we do not support hybrid engine swaps with the FlashPro as it was not designed for this. You may have issues with getting things to work properly and will not be able to resolve these issues.
Re: Reverse Lockout
Posted: Fri Jan 15, 2016 7:04 pm
by bian.yy
Spunkster wrote:I'm sorry, but we do not support hybrid engine swaps with the FlashPro as it was not designed for this. You may have issues with getting things to work properly and will not be able to resolve these issues.
The answer I want is if I load tsx manual basemap or check some of your software checkbox,will I have a pin which I can control reverse lockout. I know this pin is SLS on AT ECU.You dont need to worry about other issues,I will take responsibility.