2012 SI in recovery mode
Posted: Mon Nov 09, 2015 3:51 am
Well I had a great weekend.....My wife told me I had to SELL the SI to by a.....Umm...
Ford Fusion
I wanted to unlock my ECU to the Flashpro. I told the salesman it would only take a
second. I was in a bit of a hurry (Salespeople were hovering around the Civic). So,
I hastily plugged the Flashpro into the OBD II and re-calibrated the ECU to stock. This
would have been alright except that's about the time I realized the Civic was RUNNING!
It immediately shut off on its own. I look over to my laptop. Its dead too. The battery died.
I did see the calibration had been successfully uploaded right before my screen went out but
the car won't start.
I brought a 50' extension cord to the dealer, plugged my laptop BACK in and re-uploaded
the original stock calibration. I fired the Civic up and all was good in the world....Or at
least up until I tried to unlock the Flashpro. It said I had to reflash back to stock.....So I
did, and it died again.
I thought no big deal and attempted to re-upload the original stock calibration and get it back
to running.....At this point the ECU was displaying "X" and would not allow me to upload any calibrations.
I attempted to upload a few times with no luck and even updated the software to the latest version.
It will not allow me to calibrate. I even reset the battery....Now the radio is locked too.....yay.
Any other things I can try? Any help would....Well....Help?
Its basically sitting at the Stealership ready to be reflashed by Honda tomorrow morning.
Thank you
Ford Fusion
I wanted to unlock my ECU to the Flashpro. I told the salesman it would only take a
second. I was in a bit of a hurry (Salespeople were hovering around the Civic). So,
I hastily plugged the Flashpro into the OBD II and re-calibrated the ECU to stock. This
would have been alright except that's about the time I realized the Civic was RUNNING!
It immediately shut off on its own. I look over to my laptop. Its dead too. The battery died.
I did see the calibration had been successfully uploaded right before my screen went out but
the car won't start.
I brought a 50' extension cord to the dealer, plugged my laptop BACK in and re-uploaded
the original stock calibration. I fired the Civic up and all was good in the world....Or at
least up until I tried to unlock the Flashpro. It said I had to reflash back to stock.....So I
did, and it died again.
I thought no big deal and attempted to re-upload the original stock calibration and get it back
to running.....At this point the ECU was displaying "X" and would not allow me to upload any calibrations.
I attempted to upload a few times with no luck and even updated the software to the latest version.
It will not allow me to calibrate. I even reset the battery....Now the radio is locked too.....yay.
Any other things I can try? Any help would....Well....Help?
Its basically sitting at the Stealership ready to be reflashed by Honda tomorrow morning.
Thank you