2012 SI in recovery mode

FlashPro Manager software
Post Reply
BobRoss
Posts: 2
Joined: Mon Nov 09, 2015 3:21 am

2012 SI in recovery mode

Post by BobRoss »

Well I had a great weekend.....My wife told me I had to SELL the SI to by a.....Umm...

Ford Fusion

I wanted to unlock my ECU to the Flashpro. I told the salesman it would only take a
second. I was in a bit of a hurry (Salespeople were hovering around the Civic). So,
I hastily plugged the Flashpro into the OBD II and re-calibrated the ECU to stock. This
would have been alright except that's about the time I realized the Civic was RUNNING!
It immediately shut off on its own. I look over to my laptop. Its dead too. The battery died.
I did see the calibration had been successfully uploaded right before my screen went out but
the car won't start.

I brought a 50' extension cord to the dealer, plugged my laptop BACK in and re-uploaded
the original stock calibration. I fired the Civic up and all was good in the world....Or at
least up until I tried to unlock the Flashpro. It said I had to reflash back to stock.....So I
did, and it died again.

I thought no big deal and attempted to re-upload the original stock calibration and get it back
to running.....At this point the ECU was displaying "X" and would not allow me to upload any calibrations.
I attempted to upload a few times with no luck and even updated the software to the latest version.
It will not allow me to calibrate. I even reset the battery....Now the radio is locked too.....yay.

Any other things I can try? Any help would....Well....Help?

Its basically sitting at the Stealership ready to be reflashed by Honda tomorrow morning.


Thank you
User avatar
Hondata
Site Admin
Posts: 10616
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: 2012 SI in recovery mode

Post by Hondata »

Unplug everything, reboot the computer, switch the car off and then try again.
Make sure you using 'return to stock' rather than uploading the 'stock equivalent' calibration.
Hondata
BobRoss
Posts: 2
Joined: Mon Nov 09, 2015 3:21 am

Re: 2012 SI in recovery mode

Post by BobRoss »

Thanks for the response!

I had tried disconnecting and reconnecting, restarting, uploading the
Stock Tune. I started getting an error saying the Key needs to be turned
to 'ON' and it was just going to upload to the Flashpro, followed by a battery
error saying my battery was low.

The only thing I didn't try was grabbing and installing Flashpro on a new
computer.

I'm pretty sure the car is gone now too. They said I had until 8 AM before they
shipped it to Honda service. I just hope that fixes it.



Thanks again for your help!
Post Reply