Hondata

Is there anyway I can use the AEM output as a output on the KPRO v1.3 ecu.

I was ready something about using the ELD pin... just can't seem to find out what does the ELD correspond to.

Thanks for your help

Math

I'm not sure what you mean by K-Pro v1.3.

If you mean using the ELD input to see ELD reading you can do this but you cannot run closed loop from it.
http://www.hondata.com/help/kmanager/ecuconnectors.htm

the kpro board (pcb) is revision 1.3

There is no v1.3. It will either be a version 1, 2, 3 or 4.

What is the serial number on the K-Pro board inside the ECU?

then it's 1

I presume they sometime can be different revision..