Page 1 of 1
Adjusting tps and now car wont run
Posted: Fri Sep 25, 2015 1:24 pm
by boostedb18
So i was adjusting the tps on my s300 v3 and the car starts right up but dies immediately, the car was driving just fine until i uploaded the new settings.
What could have happened? This is my daily and i need to figure this out immediately
Re: Adjusting tps and now car wont run
Posted: Fri Sep 25, 2015 2:13 pm
by Spunkster
Close the program, reopen it, then load your calibration and upload it to the ECU again and that should correct it. You probably just had a partial upload.
Re: Adjusting tps and now car wont run
Posted: Fri Sep 25, 2015 4:48 pm
by boostedb18
Restarted the laptop and reuploaded the tune. Tps values are set to 0.63-97.23. The car starts right up but stall right away. Nothing other than the tps values were changed
Re: Adjusting tps and now car wont run
Posted: Fri Sep 25, 2015 4:55 pm
by Spunkster
What is the serial number on the s300? From Help, About, what is the version of software you are using?
Post your calibration and a datalog showing the problem.
Re: Adjusting tps and now car wont run
Posted: Fri Sep 25, 2015 5:27 pm
by boostedb18
I will post everything in the morning I'm not with the car now, thank you
Re: Adjusting tps and now car wont run
Posted: Sun Jan 17, 2016 12:53 pm
by Coupe1995
Any news on this? I'm having the same issue. As soon as I crank the car it dies immediately
Re: Adjusting tps and now car wont run
Posted: Sun Jan 17, 2016 7:21 pm
by Hondata
Follow the posting guidelines and post your details.