Page 1 of 1
Datalog values
Posted: Tue Sep 15, 2015 5:59 am
by mjalaly
How do I make a correlation between the map values in this datalog vs psi?? I am trying to figure out why my car keeps trying to stall out when i go into the higher boost range. I assume it is hitting the boost cut but i cannot tell based on the map values.
https://www.dropbox.com/sh/0i7grc1d1v3o ... taANa?dl=0
Re: Datalog values
Posted: Tue Sep 15, 2015 6:36 am
by AREA876
Post current calibration (skl file) and datalog (s3d file) of problem
Re: Datalog values
Posted: Tue Sep 15, 2015 6:42 am
by mjalaly
the datalog is int h link above, calibration attached. What i am trying to figure out though is how to read the maps numbers are PSI
Re: Datalog values
Posted: Tue Sep 15, 2015 6:46 am
by AREA876
Can you post the datalog as a s3d file
Re: Datalog values
Posted: Tue Sep 15, 2015 6:51 am
by mjalaly
not from Excel, i can do a CSV or something.
Re: Datalog values
Posted: Tue Sep 15, 2015 8:17 am
by mjalaly
Can any one else interpret the values and let me know how to convert them to psi?
Re: Datalog values
Posted: Wed Sep 16, 2015 9:08 am
by Hondata
What exactly are you seeing, and what do you think is missing? It sounds like you just need to set the units, for the table under setting and/or for the datalog values under sensors.